AudioCodes Mediant 4000 SBC - Page 744

CHAPTER40 Automatic Provisioning
Mediant 4000 SBC | User's Manual
2. Copy the master configuration file that you created in Step 1 as well as the CPT and .cmp files
to the HTTP-based provisioning server.
3. Configure each device with the following:
a. URL of the master configuration file:
◆ ini File:
IniFileURL = 'http://www.company.com/master_configuration.ini'
◆ CLI:
# configure system
(config-system)# automatic update
(automatic-update)# voice-configuration http://www.company.com/master_
configuration.ini
(automatic-update)# cli-script https://company.com/files/master_startup.txt
b. Configure the device with the IP address of the DNS server for resolving the domain name
(e.g., http://www.company.com) that is used in the URL for the provisioning server. This
is done in the IP Interfaces table:
◆ ini File:
[ InterfaceTable ]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress, InterfaceTable_
PrefixLength, InterfaceTable_Gateway, InterfaceTable_VlanID,
InterfaceTable_InterfaceName, InterfaceTable_
PrimaryDNSServerIPAddress, InterfaceTable_
SecondaryDNSServerIPAddress, InterfaceTable_UnderlyingDevice;
InterfaceTable 0 = 6, 10, 10.15.7.95, 16, 10.15.0.1, 1, "Voice",
80.179.52.100, 0.0.0.0, "vlan 1";
[ \InterfaceTable ]
◆ CLI:
# configure network
(config-network)# interface network-if 0
(network-if-0)# primary-dns 80.179.52.100
4. Power down and then power up the device.
- 711 -