CHAPTER47 Viewing Performance Monitoring
Mediant 4000 SBC | User's Manual
● Forwarded calls are not considered in the calculation for ASR and NER.
● If you don't configure thresholds for a specific metric, the device still provides
current performance monitoring values of the metric, but does not raise any
threshold alarms for it.
● You can configure the device to perform certain actions, for example, reject calls to
the IP Group for a user-defined duration, if a threshold is crossed. For more
information, see Configuring Quality of Service Rules.
The following procedure describes how to configure Performance Profile rules through the Web
interface. You can also configure it through ini file [PerformanceProfile] or CLI ( configure
system > performance-profile).
➢ To configure a Performance Profile rule:
1. Open the Performance Profile table (Monitor menu > Monitor tab > Performance
Monitoring folder > Performance Profile).
2. Click New; the following dialog box appears:
3. Configure the rule according to the parameters described in the table below.
4. Click Apply.
Table 47-2: Performance Profile Table Parameter Descriptions
Parameter Description
'Index'
[PerformanceProfile_
Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Match
'Entity'
entity
[PerformanceProfile_
Entity]
Defines a configuration entity type to which you want to apply the
rule.
■ [0] Global = (Default) The device calculates call metrics for all
calls.
■ [1] SRD = Assigns an SRD. To specify the SRD, use the 'SRD'
parameter (see below).
■ [2] IP Group = Assigns an IP Group. To specify the IP Group, use
the 'IP Group' parameter (see below).
'IP Group' Assigns an IP Group to the rule.
- 741 -
To Next Page
Loading...
