AudioCodes Mediant 4000 SBC - Page 827

CHAPTER51 Reporting Information to External Party
Mediant 4000 SBC | User's Manual
Field Description
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "TrmReasonCategory" for Syslog and Local
Storage, and "Termination Reason" for Web CDR History.
■ The maximum number of characters for Syslog tabular alignment is 17.
Termination
Reason
Value
[437]
Displays the Q.850 reason codes (1-127) for call termination. For example, "16"
for Normal Termination.
Note:
■ The field is included in the default CDR for RADIUS CDRs.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "h323-disconnect-cause=" (e.g., "h323-disconnect-
cause=16").
■ The maximum number of characters for Syslog tabular alignment is 5.
Termination
Reason
[410]
Displays the reason for the call termination. The field value is a string of up to
40 characters and is set to one of the following:
■ Standard Call Termination Reasons:
✔ "GWAPP_UNASSIGNED_NUMBER"
✔ "GWAPP_NO_ROUTE_TO_TRANSIT_NET"
✔ "GWAPP_NO_ROUTE_TO_DESTINATION"
✔ "GWAPP_SEND_SPECIAL_INFORMATION_TONE"
✔ "GWAPP_MISDIALED_TRUNK_PREFIX"
✔ "GWAPP_CHANNEL_UNACCEPTABLE"
✔ "GWAPP_CALL_AWARDED_AND"
✔ "GWAPP_PREEMPTION"
✔ "PREEMPTION_CIRCUIT_RESERVED_FOR_REUSE"
✔ "GWAPP_NORMAL_CALL_CLEAR"
✔ "GWAPP_USER_BUSY"
✔ "GWAPP_NO_USER_RESPONDING"
✔ "GWAPP_NO_ANSWER_FROM_USER_ALERTED"
✔ "MFCR2_ACCEPT_CALL"
✔ "GWAPP_CALL_REJECTED"
✔ "GWAPP_NUMBER_CHANGED"
✔ "GWAPP_REDIRECTION"
✔ "GWAPP_EXCHANGE_ROUTING_ERROR"
✔ "GWAPP_NON_SELECTED_USER_CLEARING"
✔ "RELEASE_BECAUSE_TRUNK_DISCONNECTED"
✔ "GWAPP_INVALID_NUMBER_FORMAT"
✔ "GWAPP_FACILITY_REJECT"
✔ "GWAPP_RESPONSE_TO_STATUS_ENQUIRY"
- 794 -