AudioCodes Mediant 4000 SBC - Page 885

CHAPTER57 Testing SIP Signaling Calls
Mediant 4000 SBC | User's Manual
● Test Call Rules table configuration:
◆ Endpoint URI: "101"
◆ Called URI: "201"
◆ Route By: Dest Address
◆ Destination Address: "10.30.40.01"
◆ SIP Interface: SIPInterface_0
◆ Call Party: Caller
◆ Test Mode: Once
■ Batch Test Call Scenario: This example describes the configuration of a batch test call setup
for scheduled and continuous call testing of multiple endpoints. The test call is done between
two AudioCodes devices - Device A and Device B - with simulated test endpoints. This
eliminates the need for phone users, who would otherwise need to answer and end calls many
times for batch testing. The calls are initiated from Device A, where Device B serves as the
remote answering endpoint.
● Test Call Rules table configuration at Device A:
◆ Endpoint URI: "101"
◆ Called URI: "201"
◆ Route By: Dest Address
◆ Destination Address: "10.13.4.12"
◆ SIP Interface: SIPInterface_0
◆ Call Party: Caller
◆ Maximum Channels for Session: "3" (configures three endpoints - "101", "102" and
"103)
◆ Call Duration: "5" (seconds)
◆ Calls per Sec: "1"
◆ Test Mode: Continuous
◆ Test Duration: "3" (minutes)
◆ Schedule Interval: "180" (minutes)
- 852 -