AudioCodes Mediant 4000 SBC - Page 897

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
For more information, see Configuring CSRF
Protection on page53.
http-port
[HTTPport]
Defines the LAN HTTP port for Web management.
To enable Web management from the LAN,
configure the desired port.
The default is 80.
Note: For the parameter to take effect, a device
reset is required.
[DisableWebConfig] Determines whether the entire Web interface is
read-only.
■ [0] = (Default) Enables modifications of
parameters.
■ [1] = Web interface is read-only.
When in read-only mode, parameters can't be
modified and the following pages can't be
accessed: Web User Accounts, TLS Contexts,
Time and Date, Maintenance Actions, Load
Auxiliary Files, Software Upgrade Wizard, and
Configuration File.
Note:
■ For the parameter to take effect, a device reset
is required.
[ResetWebPassword] Enables the device to restore the default
management users:
■ Security Administrator user (username "Admin";
password "Admin")
■ Monitor user (username "User"; password
"User")
In addition, all other users that may have been
configured (in the Local Users table) are deleted.
■ [0] = (Default) Disabled. Currently configured
users (usernames and passwords) are retained.
■ [1] = Default users are restored (see description
above) and all other configured users are
deleted.
Note:
■ For the parameter to take effect, a device reset
is required.
■ In addition to the ini file (see above), you can
also restore the default user accounts through
the following management platforms:
- 864 -