AudioCodes Mediant 4000 SBC - Page 903

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
[KeepAliveTrapPort] Defines the port of the SNMP network
management station to which the device
sends keep-alive traps.
The valid range is 0 - 65534. The default is
port 162.
To enable NAT keep-alive traps, use the
[SendKeepAliveTrap] parameter.
[PM_EnableThresholdAlarms] Enables the sending of the SNMP trap event
acPerformanceMonitoringThresholdCrossin
g, which is sent every time the threshold
(high or low) of a Performance Monitored
object (e.g.,
acPMSIPSBCAttemptedCallsTable) is
crossed.
■ [0] = (Default) Disable
■ [1] = Enable
Note: Once enabled, you can change the
low and high threshold values per
performance monitored object. For more
information, see the SNMP Reference
Guide for Gateways-SBCs-MSBRs.
[ShortCallSeconds] Defines the duration (in seconds) of a call for
it to be considered a short call and thus,
included in the count of the performance
monitoring SNMP MIBs for short calls
(acPMSBCInShortCallsTable,
acPMSBCOutShortCallsTable,
acPMSBCSRDInShortCallsTable,
acPMSBCSRDOutShortCallsTable,
acPMSBCIPGroupInShortCallsTable, and
acPMSBCIPGroupOutShortCallsTable).
The valid value is 0 to 60. The default is 2. A
value of 0 indicates calls of zero duration,
which are calls that do not pass the device's
Classification, Manipulation or Routing
stages.
Note: The parameter is applicable only to
the SBC application.
configure system > snmp settings
> sys-oid
[SNMPSysOid]
Defines the SNMP MIB OID for the base
product system.
The default is 1.3.6.1.4.1.5003.8.1.1.
Note:
■ For the parameter to take effect, a
device reset is required.
■ The device automatically adds the
device’s unique product identifier
number at the end of your OID.
- 870 -