CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
'Log Severity Level'
log-level
[SyslogLogLevel]
Defines the minimum severity level of messages included
in the Syslog message that is generated by the device.
The specified severity level and all higher severity levels
are included in the Syslog message. For example, if you
configure the parameter to Alert, the Syslog will include
messages with Alert severity level and messages with
Fatal severity level. The severity levels are listed below
from highest to lowest.
■ [0] Fatal
■ [1] Alert
■ [2] Critical
■ [3] Error
■ [4] Warning
■ [5] Notice (default)
■ [6] Info
■ [7] Debug
'CDR Server IP Address'
configure troubleshoot
> cdr > cdr-srvr-ip-
adrr
[CDRSyslogServerIP]
Defines the destination IP address to where CDR logs are
sent.
The default value is a null string, which causes CDR
messages to be sent with all Syslog messages to the
Syslog server.
Note:
■ The CDR messages are sent to UDP port 514 (default
Syslog port).
■ This mechanism is active only when Syslog is enabled
(i.e., the parameter [EnableSyslog] is set to [1]).
'Call-End CDR SIP Reasons
Filter'
configure troubleshoot
> cdr > call-end-cdr-
sip-reasons-filter
[CallEndCDRSIPReasonsFilter]
Defines SIP release cause codes that if received for the
call, the devicedoes not sent Call-End CDRs for the call.
The valid value is 300 through to 699. You can configure
the parameter with multiple codes using a comma to
separate them (e.g., 301,400,404). You can also use "xx"
to denote a range (e.g., 3xx).
'Call-End CDR Zero Duration
Filter'
configure troubleshoot
> cdr > call-end-cdr-
zero-duration-filter
[CallEndCDRZeroDurationFilter]
Enables the device tonot send Call-End CDRs if the call's
duration is zero (0).
■ [0] Disable (default)
■ [1] Enable
'CDR Report Level'
configure troubleshoot
> cdr > cdr-report-
level
[CDRReportLevel]
Enables signaling-related CDRs to be sent to a Syslog
server and defines the call stage at which they are sent.
■ [0] None = (Default) CDRs are not used.
■ [1] End Call = CDR is sent to the Syslog server at the
end of each call.
■ [2] Start & End Call = CDR report is sent to Syslog at
the start and end of each call.
- 893 -
To Next Page
Loading...
