EasyManua.ls Logo

AudioCodes Mediant 4000 SBC - Page 953

AudioCodes Mediant 4000 SBC
1037 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
The device uses the following algorithm to calculate the
incremental augmented wait-time between each
registration attempt:
Wait Time = min (max-time, (base-time *
(2 ^ consecutive-failures)))
Where:
max-time is the value configured by
MaxRegistrationBackoffTime
base-time is the value configured by
RegistrationRetryTime
For example, if max-time is 1800 seconds and base-
time is 30 seconds, and there were three consecutive
registration failures, then the upper-bound wait time is
the minimum of (1800, 30*(2^3)), which is (1800, 240)
and thus, the minimum of the two values is 240
(seconds). The actual time the device waits before
retrying registration is computed by a uniform random
time between 50% and 100% of the upper-bound wait
time (e.g., for an upper-bound wait-time of 240, the
actual wait-time is between 120 and 240 seconds). As
can be seen from the algorithm, the upper-bound wait
time can never exceed the value of the
MaxRegistrationBackoffTime parameter.
'Registration Time Threshold'
configure voip > sip-
definition proxy-and-
registration >
registration-time-thres
[RegistrationTimeThreshold]
Defines a threshold (in seconds) for re-registration
timing. If the parameter is greater than 0, but lower than
the computed re-registration timing (according to the
parameter RegistrationTimeDivider), the re-registration
timing is set to the following: timing set by the
Registration server in the SIP Expires header minus the
value of the parameter RegistrationTimeThreshold.
The valid range is 0 to 2,000,000. The default is 0.
'ReRegister On Connection Failure'
configure voip > sip-
definition proxy-and-
registration > reg-on-
conn-failure
[ReRegisterOnConnectionFailure]
Enables the device to perform SIP re-registration upon
TCP/TLS connection failure.
[0] Disable (default)
[1] Enable
configure voip > sip-
definition proxy-and-
registration > expl-un-
reg
[UnregistrationMode]
Enables the device to perform explicit unregisters.
[0] Disable (default)
- 920 -

Table of Contents

Other manuals for AudioCodes Mediant 4000 SBC

Related product manuals