CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
configure voip >
sip-definition
settings >
phone-in-from-
hdr
[IsUserPhoneInFrom]
'Use Tel URI for
Asserted Identity'
configure voip >
sip-definition
settings > uri-
for-assert-id
[UseTelURIForAssert
edID]
Defines the format of the URI in the P-Asserted-Identity and P-
Preferred-Identity headers.
■ [0] Disable = (Default) 'sip:'
■ [1] Enable = 'tel:'
configure voip >
sip-definition
settings > p-
preferred-id-
list
[PPreferredIdListMod
e]
Defines the number of P-Preferred-Identity SIP headers included in
the outgoing SIP message when the header contains multiple
values.
■ [0] = (Default) The device includes multiple P-Preferred-Identity
SIP headers in the outgoing message, for example:
✔ Incoming message containing a P-Preferred-Identity header
with multiple values:
P-Preferred-Identity:
<sip:someone@test.org>,<tel:+123456789>
✔ Outgoing message sent with multiple P-Preferred-Identity
headers, each with a value:
P-Preferred-Identity: <sip:someone@test.org>
P-Preferred-Identity: <tel:+123456789>
■ [1] = The device includes only one P-Preferred-Identity header in
the outgoing message, for example:
✔ Incoming message containing multiple P-Preferred-Identity
headers:
P-Preferred-Identity: <sip:someone@test.org>
P-Preferred-Identity: <tel:+123456789>
✔ Outgoing message sent with a single P-Preferred-Identity
header containing the multiple values:
P-Preferred-Identity:
<sip:someone@test.org>,<tel:+123456789>
Note:
- 933 -
To Next Page
Loading...
