AudioCodes Mediant 4000 SBC - Page 994

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
configure voip > media rtp-rtcp >
fax-bypass-payload-type
[FaxBypassPayloadType]
The valid range is 0 to 127. The default is
102.
configure voip > media rtp-rtcp >
modem-bypass-payload-type
[ModemBypassPayloadType]
Defines the modem bypass dynamic
payload type.
The range is 0 to 127. The default is 103.
volume
[FaxModemRelayVolume]
Defines the fax gain control.
The range is -18 to -3, corresponding to -
18 dBm to -3 dBm in 1-dB steps. The
default is -6 dBm fax gain control.
'Fax Bypass Output Gain'
configure voip > media fax-modem >
fax-bypass-output-gain
[FaxBypassOutputGain]
Defines the fax bypass output gain
control.
The range is -31 to +31 dB, in 1-dB
steps. The default is 0 (i.e., no gain).
'Modem Bypass Output Gain'
configure voip > media fax-modem >
modem-bypass-output-gain
[ModemBypassOutputGain]
Defines the modem bypass output gain
control.
The range is -31 dB to +31 dB, in 1-dB
steps. The default is 0 (i.e., no gain).
modem-bypass-output-gain
[FaxModemBypassBasicRTPPacketInterval]
Defines the basic frame size used during
fax/modem bypass sessions.
■ [0] = (Default) Determined internally
■ [1] = 5 msec (not recommended)
■ [2] = 10 msec
■ [3] = 20 msec
Note: When set to 5 msec (1), the
maximum number of simultaneous
channels supported is 120.
jitter-buffer-minimum-delay
[FaxModemBypasDJBufMinDelay]
Defines the Jitter Buffer delay (in
milliseconds) during fax and modem
bypass session.
The range is 0 to 150 msec. The default
is 40.
enable-fax-modem-inband-network-
detection
[EnableFaxModemInbandNetworkDetection]
Enables in-band network detection
related to fax/modem.
■ [0] = (Default) Disable.
- 961 -