AudioCodes Mediant 4000 SBC - Page 996

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
■ [0] Initiate T.38 on Preamble =
(Default) The device to which the
called fax is connected initiates a
T.38 session on receiving . Preamble
signal from the fax.
■ [1] Initiate T.38 on CED = The
device to which the called fax is
connected initiates a T.38 session on
receiving a CED answer tone from
the fax. This option can only be used
to relay fax signals, as the device
sends T.38 Re-INVITE on detection
of any fax/modem Answer tone (2100
Hz, amplitude modulated 2100 Hz, or
2100 Hz with phase reversals). The
modem signal fails when using T.38
for fax relay.
Note: The parameters is applicable only
if the IsFaxUsed parameter is set to 1
(T.38 Relay) or 3 (Fax Fallback).
'CED Transfer Mode'
configure voip > media fax-modem >
ced-transfer-mode
[CEDTransferMode]
Defines the method for sending
fax/modem CED (answering) tones.
■ [0] Fax Relay or VBD = (Default)
The device transfers the CED tone in
Relay mode and starts the fax
session immediately.
■ [1] Voice Mode or VBD = The
device transfers the CED tone in
either Voice or Bypass mode and
starts the fax session on V21
preamble.
■ [2] RFC 4733 Blocking RTP VBD =
The device transfers the CED tone in
RFC 2833. This is applicable only to
V.150.1 modem relay and fax
bypass.
■ [3] RFC 4733 Along with RTP
VBD = The device transfers the CED
tone in RFC 2833 and bypass, in
parallel. For combined V.150.1
modem relay and fax relay, use this
option.
V.150.1 Modem over IP
'Profile Number'
[V1501AllocationProfile]
Defines the V.150.1 profile, which
determines how many DSP channels
support V.150.1.
The value range is 0 to 20. The default is
0.
- 963 -