AudioCodes MSBR Series User Manual

CHAPTER2 SNMP Trap Alarms
MSBR | SNMP Alarms
Alarm acTrunksAlarmFarEndLOF
Severity Condition Text Corrective Action
Critical RAI "Trunk RAI Alarm" Make sure that
transmission is correct.
Cleared End of RAI - -
DS1 Line Status Alarm
The alarm is applicable only to digital PSTN interfaces.
Table 2-5: dsx1LineStatusChange
Alarm dsx1LineStatusChange
OID 1.3.6.1.2.1.10.18.15.0.1
Default
Severity
Major on raise; Clear on clear
Source
Varbind
Text
Interfaces#0/Trunk#<m>, where m is the trunk interface number, 1 being
the first trunk
Event Type communicationsAlarm
Probable
Cause
Severity Text Additional Info1,2,3
- DS1 Line
Status
Updated DS1 Line Status.
This variable indicates the Line Status of the interface. It
contains loopback, failure, received 'alarm' and
transmitted 'alarms' information.
dsx1LineStatus is a bitmap represented as a sum, so it
can represent multiple failures (alarms) and a
LoopbackState simultaneously.
dsx1NoAlarm must be set if and only if no other flag is
set.
If the dsx1loopbackState bit is set, the loopback in effect
can be determined from the dsx1loopbackConfig object.
The various bit positions are:
1dsx1NoAlarmNo alarm present
- 13 -

AudioCodes MSBR Series Specifications

General

Brand	AudioCodes
Model	MSBR Series
Category	Security System
Language	English