AudioCodes MSBR Series - Network Quality Monitoring; NQM Connectivity Alarm

CHAPTER2 SNMP Trap Alarms
MSBR | SNMP Alarms
Alarm acIpGroupNoRouteAlarm
mentioned reasons. blocked.
IPGroup(<name>)
Blocked Reason:
<reason – see
Source Varbind
Text>"
Cleared When calls are no longer
rejected due to the above-
mentioned reasons (i.e. when
none of the above reasons
prevent a route to the IP Group
from being established).
-
Network Quality Monitoring
This section describes the alarms concerned with the Network Quality Monitoring (NQM)
feature.
NQM Connectivity Alarm
Table 2-46: acNqmConnectivityAlarm
Alarm acNqmConnectivityAlarm
OID 1.3.6.1.4.1.5003.9.10.1.21.2.0.88
Description The alarm is sent when the device loses connectivity with the
Network Quality Monitoring (NQM) probe destination.
Default Severity
Alarm Source Board#%d/NqmSender#%d
Event Type communicationsSubsystemFailure
Probable Cause The alarm is sent when connectivity with the NQM probe
destination is lost.
Alarm Severity Condition Text Corrective Action
Minor - "Connectivity with
NQM probe
destination is lost"
Cleared when
connectivity with the
Noise Quality Measure
(NQM) probe
- 56 -