AUMA ACV 01.2 - Page 3

336.3.3. DS intermediate frame for double sealing
346.3.4. External earth connection
357. Operation................................................................................................................................
357.1. Manual operation
357.1.1. Manual operation: engage
357.1.2. Manual operation: disengage
357.2. Motor operation
357.2.1. Operating the actuator from local controls
367.2.2. Actuator operation from remote
377.3. Menu navigation via push buttons (for settings and indications)
387.3.1. Menu layout and navigation
397.4. User level, password
397.4.1. Password entry
397.4.2. Password change
407.5. Language in the display
407.5.1. Language change
428. Indications..............................................................................................................................
428.1. Indications during commissioning
428.2. Indications in the display
438.2.1. Feedback signals from actuator and valve
458.2.2. Status indications according to AUMA classification
468.2.3. Status indications according to NAMUR recommendation
488.3. Indication lights of local controls
488.4. Mechanical position indication (self-adjusting)
498.5. Mechanical position indication via indicator mark (not self-adjusting)
509. Signals (output signals).........................................................................................................
509.1. Signals via Profinet
509.2. Status signals via output contacts (digital outputs)
509.2.1. Assignment of outputs
509.2.2. Coding the outputs
509.3. Analogue signals (analogue outputs)
5210. Commissioning (basic settings)...........................................................................................
5210.1. End stops in part-turn actuator
5310.1.1. End stop CLOSED: set
5310.1.2. End stop OPEN: set
5410.2. Type of seating: set
5510.3. Torque switching: set
5710.4. Limit switching: set
5810.5. Operating time (internal): set
6010.6. Test run
6010.6.1. Direction of rotation at mechanical position indicator: check
6110.6.2. Limit switching: check
6211. Commissioning (settings in the actuator)...........................................................................
6311.1. Switch compartment: open/close
6311.2. Mechanical position indicator (self-adjusting)
6311.2.1. Mechanical position indicator: set
6411.2.2. Gear stage of the reduction gearing: test/set
6511.3. Mechanical position indication via indicator mark (not self-adjusting)
3
SQV 05.2 – SQV 14.2 / SQRV 05.2 – SQRV 14.2 Control unit: electronic (MWG)
ACV 01.2 Non-Intrusive Profinet Table of contents