Austro Engine AE300-Wizard - Page 80

AE300-Wizard
Document No.: E4.08.09 E4.08.09 : AE_xx_000
Revision: 13 9 : 00
Page: 80 of 89
Copyright © 2019, Austro Engine GmbH
Dept.: Electric/Electronic
Type: User Guide
To document the successful software update, the following three files are required:
1. Engine data (i.e. serials, HW and SW versions) before the software update:
This is contained in the automatically saved engine log file presented in step 7)
above:
In “My Documents\Austro Engine\AE300-Wizard\Engine_Log”
as “Flash_Autosave_Engine_Log_YYYYMMDD_hhmmss.ae3”
2. Logfile of the software update process:
In “My Documents\Austro Engine\AE300-Wizard\Flash”
as “FlashLog_EECU-Serial-number_YYYYMMDD_hhmmss.ae3”
3. Engine data (i.e. serials, HW and SW revisions) after the software update
It is contained in the engine log file to be saved during step 9) above:
In “My Documents\Austro Engine\AE300-Wizard\Engine_Log”
as “Engine_Log_YYYYMMDD.ae3”
8a) If the information in the RED MESSAGE BOX after an unsuccessful software update
suggests a retry of the update process – continue with section “10.4 Software Up-
date Retry” on page 82.