Introduction
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 3
Table of Contents
1. Introduction ...................................................................... 7
1.1 About the Handbook .......................................................................... 7
1.2 Hardware / Software .......................................................................... 7
1.3 The Reader ....................................................................................... 7
1.4 Reference Documentation................................................................. 8
2. Safety ................................................................................ 9
2.1 Important Safety Information ............................................................. 9
2.2 National Standards and Regulations ................................................. 10
2.3 Technical Documentation .................................................................. 10
2.4 Recommendations for latest available Firmware and Operating
System............................................................................................... 10
2.5 System Design, Installation, Commissioning, Testing and
Validation ........................................................................................... 11
2.6 Modifications to the products ............................................................ 11
2.7 Safety Notices ................................................................................... 12
2.8 Compliance with Standards and Directives ....................................... 12
2.8.1 Standards NFPA 70 and NFPA 72 ......................................... 12
2.9 Environment Compatibility................................................................. 13
2.9.1 Recycling ................................................................................. 13
2.9.2 Disposal .................................................................................. 13
3. Pre-installation ................................................................. 14
3.1 Location ............................................................................................. 14
3.2 Environmental Requirements ............................................................ 14
3.3 Mounting Height / Space Requirement ............................................. 14
4. System Units – Overview ................................................ 15
4.1 Power Supplies ................................................................................. 17
5. Loop Panels – Overview .................................................. 18
6. Mounting Instructions ..................................................... 19
6.1 Introduction ........................................................................................ 19
6.2 Mounting Fire Alarm Control Panel BS-420/Controller BC-420 ........ 20
6.3 Mounting the Operator Panel BS-430 ............................................... 22
6.4 Mounting Repeater Panel BU-BV-420 .............................................. 23
6.5 Mounting Loop Panels (BV-110 and BU-110) ................................... 25
6.6 Mounting Power Cabinet STX Range ............................................... 26
6.7 Mounting Power Supply Unit BPS-410 ............................................. 27
6.8 Inserting Text Foils ............................................................................ 28
6.9 Cable Inlets / Outlets ......................................................................... 29
6.10 Cut Out Dimensions for Flush Mounting in a Wall ............................ 30
6.10.1 Repeater Panel BU-BV-420 .................................................... 30
6.10.2 Operator Panel BS-430 ........................................................... 31
To Next Page
Loading...
