Mounting Instructions
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 26
6.6 Mounting Power Cabinet STX Range
AutroSafe Release 4 provides Power Cabinet STX Range. The power
cabinet is available in three different versions, including either a 2A, 5A
or 10A power supply. All versions have space for two 12V/18Ah
batteries (not included).
To ensure proper mounting and installation, we recommended that the
manual for the power cabinet in question (2A, 5A or 10A) is read and
followed.
2A power cabinet:
http://product.autronicafire.com/fileshare/filarkivroot/produkt/dokumenta
sjon/PAK200582_02D%20STX2402.pdf
5A power cabinet:
http://product.autronicafire.com/products/fire-and-gas-detection-
systems/fg-system-units/power-supply-units/stx-5a/
10A power cabinet:
http://product.autronicafire.com/products/fire-and-gas-detection-
systems/fg-system-units/power-supply-units/stx-10a/
Note that the Power Cabinet must be mounted maximum 10 cm away
from the Fire Alarm Control Panel BS-420 or a Controller BC-420.
For power distribution to fire alarm controller, check the schematics
included in the datasheet for the power cabinet that is to be used.
To Next Page
Loading...
Need help?
General
