Avaya Aura System Platform User Manual

2. To configure eth0 or eth1 or both, perform the following tasks:
• Use the Tab key to highlight the Physical Devices field.
• Use the down arrow or the up arrow key to highlight eth0 or eth1 in the
Physical Devices field.
• Complete the Static IP field.
The server displays a default value for the Subnet mask field. You can modify
this field.
Note:
Avaya recommends that you use the default value of 192.11.13.6 for eth1.
3. Complete the Default gateway IP field.
Note:
Although you can enter default gateway for each interface, you should specify
only one default gateway. Specifying more than one default gateway may result
in an unusable internal networking configuration. Specifying one valid default
gateway is mandatory for the System Platform installation.
Important:
Be careful not to use the Tab key on other ethernet interfaces. Set eth0 to the
customer IP address and set eth1 to the services IP address. Do not configure
eth2 and eth3.
4. Use the Tab key to highlight OK and press Enter to accept the configuration and
display the System Platform Console Domain Network Configuration screen.
Installing System Platform using server console
64 Installing and Configuring Avaya Aura
™
System Platform April 2010

Avaya Aura System Platform Specifications

General

Brand	Avaya
Model	Aura System Platform
Category	Server
Language	English