Avaya Aura System Platform - Formatting a USB Drive

Formatting a USB drive
1. Insert your USB drive and note the assigned device (typically /dev/sdb) by typing
dmesg.
The system displays output similar to the one shown below:
2. Run the command fdisk on the device.
3. Enter m to get a list of commands.
The system displays output similar to the one shown below:
4. If required, type d to delete a partition on the USB drive.
The system displays output similar to the one shown below:
5. If required, type p to print the USB drive information.
Formatting a USB drive
Installing and Configuring Avaya Aura
™
System Platform April 2010 89