2. If the Branch Gateway is being mounted in a rack with other equipment already installed, the
Branch Gateway must be positioned to avoid imbalance.
Result
Note:
The Branch Gateway weighs under 11 pounds (5 kg) empty and between 13 and 14 pounds
(between 6 and 7 kg) when equipped with media modules. The EM200 weighs under 11 pounds
(5 kg) empty and between 12 and 13 pounds (between 5 and 6 kg) when equipped with media
modules.
Related links
Branch Gateway racks on page 22
Mounting the Branch Gateway in the rack
Procedure
1. Position the Branch Gateway in the rack.
Ensure that there is adequate ventilation.
2. Verify that the screw holes are aligned with the rack hole positions.
Related links
Branch Gateway racks on page 22
Mounting the Branch Gateway on a wall
About this task
Note:
You can only mount a G430 on a wall if you do not attach any EM200 modules to it.
To mount the Branch Gateway on a wall, use the two wall mounting brackets You can also add a
mounting bracket with cable guides if desired, as explained in
Brackets with cable guides on
page 23.
Caution:
If you are installing the Branch Gateway in the United States of America:
• The AC power supply cord must not be attached to the building wall, for example with wire
staples, clamps, and so on.
• You must install the Branch Gateway near the AC receptacle (socket outlet) that services
the Branch Gateway.
• You must install the AC power supply cord in a way that minimizes the risk of physical
damage to the cord. The cord must not be hanging on the floor, or routed in any way that
can subject it to physical abuse.
Related links
Mounting the Branch Gateway chassis on page 21
Attaching brackets to the Branch Gateway for wall mounting on page 26
Branch Gateway installations
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 25
Comments on this document? infodev@avaya.com
To Next Page
