For instructions on accessing the Avaya Aura
®
Communication Manager through
the Branch Gateway, see Accessing the registered MGC on page 72.
2. At the SAT, enter change node-names ip to display the IP Node Names
screen.
For example:
change ip-codec-set-1 Page 1 of 3
IP NODE NAMES
Name IP Address Name IP Address
Denver Gateway1 192.168.1 .200
. . .
procr
192.168.1 .201
. . .
(X of X administered node-names were displayed )
Use 'list node-names' command to see all the administered node-names
Use 'change node-names ip xxx' to change a node-name 'xxx' or add a node-
name
3. In the Modem field, type v150mr.
Note:
Set the name of the Branch Gateway consistently with the Name field on the
Media Gateway Administration screen in Communication Manager (add
media-gateway) and with the name used in the set system name command
(gateway CLI).
4. Type the IP address of the Branch Gateway in the IP Address field.
5. Submit the screen.
6. At the SAT, enter change system-parameters mg-recovery-rule 1 to
display the System Parameters Media Gateway Automatic Recovery Rule
screen.
7. Type a description of the rule in the Rule Name field.
8. Set the Migrate H.248 MG to primary field to immediately.
Note:
The immediately value is only one of the four possible choices. See the
Administrator Guide for Avaya Aura
®
Communication Manager for more
information on the values for this field.
9. Submit the screen.
10. At the SAT, enter display media-gateway 1 to display the Media Gateway
screen.
11. Verify the following fields:
• Name field (20 characters maximum) must match the administered name of
the gateway (see Step
2 on page 164 of Configuring the SLS data through
the CLI on page 163).
Standard Local Survivability (SLS)
Administering Avaya G430 Branch Gateway October 2013 121
To Next Page
Loading...
