Avaya G430 - Page 164

Note:
Review Summary of SLS configuration commands on page 187 in its entirety before
proceeding with SLS administration. This summary of SLS commands guides you in
understanding the various sub-commands of each sub-context.
Creating the SLS administration data set on the Branch Gateway
Procedure
1. Log on to the Branch Gateway.
2. To administer the name, enter set system name name, where name is typed
inside quotation marks (“”).
To remove the administered name, enter set system name, and then rename
the Branch Gateway using the set system name command.
Note:
The Branch Gateway’s administered name must match the name in the
Communication Manager administration.
3. At the Branch Gateway command prompt, enter sls to begin entering SLS data.
The command line prompt changes to (super-sls)# to indicate that you are in SLS
data entry mode. Entering exit ends the SLS data entry mode session, and the
command line prompt returns to its original state.
4. Enter set pim-lockout yes to prevent Provisioning and Installation Manager
(PIM) updates while you are working on SLS administration of the Branch
Gateway.
5. If you want to change the maximum allowable IP registrations from the default, enter
set max-ip-registrations n, where n is from 1 to 150.
6. Use the set date-format command to set a date format for the SLS data set.
7. Use the set ip-codec-set command to select the country-specific G.711 codec
set within the SLS data set: g.711mu or g.711a.
8. Administer the slot configuration information by entering set slot-config
slot-number board-type, where slot-number is the slot where the Media
Module is located and board-type is the Media Module type.
See
Media module compatibility with SLS on page 102
9. Administer the station information.
See Administering station parameters on page 166.
10. Administer DS1 trunks as required.
Refer to
Administering DS1 parameters on page 170.
Standard Local Survivability (SLS)
164 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com