Name Description
then the value of tone is used instead. Note
that this does not apply to DS1 PRI links.
Trunk Group Number This value is used in the routing table
TAC This value is only necessary if the Dial
Access? field is set to y. If that field is set to
n, the TAC value is not pushed down to the
media gateway.
Port There may be more than one port within a
trunk group definition that pertains to a given
media gateway
Digit Treatment This only applies for DID analog trunks or for
DS1 tie trunks. Note that this does not apply
to DS1 PRI tie trunks.
Digits This field contains a value only when the
Digit Treatment field is set to insert1,
insert2, insert3, or insert4
Trunk Type Depends on trunk signaling type:
• Analog trunks:
- Loop-start
- Ground-start
- DID
• In-Band DS1 trunks with CO Group-Type:
- Loop-start
- Ground-start
• In-Band DS1 trunks with Tie Group-Type:
- Wink/wink
- Wink/immediate
- Wink/auto
- Immediate/Immediate
- Auto/auto
- Auto/wink
Group Name Customer identification of trunk group
Codeset to Send Display Describes which Q.931 code-sets are
allowed to send Display IEs
Codeset to Send National IEs Describes which Q.931 code-sets are
allowed to send National supported IEs
Standard Local Survivability (SLS)
146 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
