Avaya G430 - Page 154

Primary D-channel
Specifies the gateway port ID where the D-channel is located. For the gateways, the first
component is the three digit gateway number, followed by a ‘v’, the slot number, and 24 (T1)
or 16 (E1).
Trunk Board
This is needed only if the Associated Signaling is set to no . This does not apply to SLS on the
G250. Specifies the gateway port ID where the D-channel is located. For the gateways, the
first component is the three digit gateway number, followed by a “v”, and one numeric character
for the slot number.
Interface Id
Needed only if the Associated Signaling is set to no. Specifies the channel of the DS1 circuit
that carries the D-channel for ISDN signaling. This is an integer from 0 through 31.
Collecting administered ISDN-BRI trunks data
Procedure
1. At the SAT, enter display bri-trunk-board location to display the DS1
administration for a particular circuit pack location.
2. Gather the following ISDN-BRI administration information for each location:
• Name
• Interface
• Side
• Country Protocol
• DCP/Analog Bearer Capability
• Companding Mode
• TEI
• Directory Number A
• Directory Number B
• SPID-A
• SPID-B
• Endpt Init
• Layer 1 Stable
Standard Local Survivability (SLS)
154 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com