Examples of configuring DHCP client logging messages
• set logging session enable command example.
Gxxx-001# set logging session enable
Done!
CLI-Notification: write: set logging session enable
• set logging session condition dhcpc example:
Gxxx-001# set logging session condition dhcpc Info
Done!
CLI-Notification: write: set logging session condition dhcpc Info
Note:
You can also enable logging messages to a log file or a Syslog server. For a full description
of logging on the Branch Gateway, see
System logging on page 215.
For a description of these commands, see Summary of DHCP client configuration CLI
commands on page 208 or Avaya G430 Branch Gateway CLI Reference.
Summary of DHCP client configuration CLI commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
Command Description
clear ip
dhcp-client
statistics
Clear the DHCP client statistics counters
interface
fastethernet
Enter interface fastethernet configuration
mode
clear ip dhcp-
client statistics
Clear the DHCP client statistics counters
ip address dhcp Enable or disable IP address negotiation
via DHCP (applies to WAN FastEthernet
interfaces only)
ip dhcp client
client-id
Set the client identifier for the DHCP client
Ethernet ports
208 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
