Avaya G430 - Page 217

For example:
Gxxx-001(super)# set logging server 147.2.3.66
Done!
or
Gxxx-001(super)# set logging server 2001:db8:2179::1
Done!
2. Enable the Syslog server by entering set logging server enable followed
by the IP address of the Syslog server.
When you define a new Syslog server, it is defined as disabled, so you must use
this command in order to enable the server.
For example:
Gxxx-001(super)# set logging server enable 147.2.3.66
Done!
3. Optionally, define an output facility for the Syslog server by typing the set
logging server facility command, followed by the name of the output
facility and the IP address of the Syslog server.
If you do not define an output facility, the default local7 facility is used.
For example:
Gxxx-001(super)# set logging server facility auth 147.2.3.66
Done!
The following is a list of possible facilities:
• auth. Authorization
• daemon. Background system process
• clkd. Clock daemon
• clkd2. Clock daemon
• mail. Electronic mail
• local0 – local7. For local use
• ftpd. FTP daemon
• kern. kernel
• alert. Log alert
• audi. Log audit
• ntp. NTP subsystem
• lpr. Printing
• sec. Security
• syslog. System logging
• uucp. Unix-to-Unix copy program
System logging
Administering Avaya G430 Branch Gateway October 2013 217