• news. Usenet news
• user. User process
4. Optionally, limit access to the Syslog server output by typing the set logging
server access-level command, followed by an access level (read-only, read-
write, or admin) and the IP address of the Syslog server.
If you do not define an access level, the default read-write level is used.
For example:
Gxxx-001(super)# set logging server access-level read-only 147.2.3.66
Done!
Only messages with the appropriate access level are sent to the Syslog output.
5. Optionally, define filters to limit the types of messages received (see Logging filter
configuration on page 224).
Disabling Syslog servers
Procedure
Enter set logging server disable followed by the IP address of the Syslog
server.
For example:
Gxxx-001(super)# set logging server disable 147.2.3.66
Done!
Deleting Syslog servers
About this task
You can delete a Syslog server from the Syslog server table.
Procedure
Enter clear logging server followed by the IP address of the Syslog server you
want to delete.
For example:
Gxxx-001(super)# clear logging server 147.2.3.66
Done!
System logging
218 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
