Avaya G430 - Page 279

•
keepalive-icmp failure-retries
•
keepalive-icmp interval
• keepalive-icmp source-address.
•
show keepalive-icmp
For more information about these commands, see Summary of ICMP keepalive configuration
commands on page 279
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Example of configuring ICMP keepalive
The following example configures ICMP keepalive on interface fastethernet 10/2 to send
keepalive packets to IP address 135.64.2.12 using MAC address 11.22.33.44.55.66, at five
second intervals. If a response is not received within one second, the keepalive packet is
considered to have failed. After three consecutive failed packets, the interface is declared to
be down. After two consecutive successful packets, the interface is declared to be up.
Gxxx-001# interface fastethernet 10/2
Gxxx-001(super-if:FastEthernet 10/2)# keepalive-icmp 135.64.2.12
11.22.33.44.55.66
Gxxx-001(super-if:FastEthernet 10/2)# keepalive-icmp interval 5
Gxxx-001(super-if:FastEthernet 10/2)# keepalive-icmp timeout 1
Gxxx-001(super-if:FastEthernet 10/2)# keepalive-icmp failure-retries 3
Gxxx-001(super-if:FastEthernet 10/2)# keepalive-icmp success-retries 2
Done!
Summary of ICMP keepalive configuration commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
Command Description
interface
fastethernet
Enter the FastEthernet interface configuration
context
keepalive-icmp Enable the ICMP keepalive mechanism on an
interface in the context of the interface. Use
the no form of this command to deactivate the
feature.
Includes the following parameters:
• destination ip address. The
destination IP address for the keepalive
packets.
• next hop MAC address. The next hop
MAC address for the keepalive packets.
WAN interfaces
Administering Avaya G430 Branch Gateway October 2013 279