Avaya G430 - Page 335

Enabling and disabling redundancy pairs
Procedure
To globally enable or disable the redundancy pairs you have defined, use the set
port redundancy enable/disable command.
This command does not delete existing redundancy entries.
Defining or removing redundancy pairs
1. To define or remove redundancy pairs, see the set port redundancy
command.
2. To ensure that there is no redundancy scheme already defined on any of the links,
enter show port redundancy.
Configuring time constants
Procedure
To configure the two time constants that determine redundancy switchover
parameters, use the set port redundancy-intervals command.
Displaying port redundancy schemes
Procedure
To display information about software port redundancy schemes defined for the switch,
enter show port redundancy.
Advanced switching
Administering Avaya G430 Branch Gateway October 2013 335