Avaya G430 - Page 336

Port redundancy configuration examples
The following example creates a port redundancy pair:
G430-001(super)# set port redundancy 10/3 10/4 on 1
Monitor: Port 10/4 is redundant to port 10/3.
Port redundancy is active - entry is effective immediately
The following example deletes a port redundancy pair:
G430-001
(super)# set port redundancy 10/3 10/4 off
Entry Monitor removed: Port 10/4 is not redundant to port 10/3
The following example enables all configured port redundancies:
Gxxx-001(super)# set port redundancy enable
All redundancy schemes are now enabled
The following example disables all configured port redundancies:
Gxxx-001(super)# set port redundancy disable
All redundancy schemes are disabled but not removed
The following example configures the switchback interval for all configured port redundancies:
Gxxx-001(super)# set port redundancy-intervals 60 30
Done!
The following example displays port redundancy information:
G430-001
(super)# show port redundancyRedundancy Name Primary Port Secondary
Port Status
----------------- -------------- ---------------- --------
Monitor 10/3 10/4 primary
Minimum Time between Switchovers: 60
Switchback interval: 30
Summary of port redundancy commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
Description
set port redundancy Define or remove redundancy pairs
set port redundancy
enable|disable
Globally enable or disable port redundancy pairs
defined on the Branch Gateway
Advanced switching
336 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com