Avaya G430 - Page 417

Displaying test results
Procedure
Use any of the following commands to display test results:
• In the analog-test context, use the show result command to display the result
of the latest measurements performed for a particular profile.
• In the analog-test-profile context, use the show result command to display the
results of the latest measurements performed by the test profile.
Result
If a test did not succeed, the output indicates the reason for the test failure.
Healing trunks
About this task
You can manually tune three parameters on each analog trunk port: balance, receive-gain,
and transmit gain.
Procedure
1. Enter analog-test to enter the analog-test context.
2. Correct the balance, receive-gain, or transmit-gain of a port using the following
commands:
• Use the set balance command to set the balance on a specific port.
• Use the set receive-gain command to set the receive-gain on a specific
port.
• Use the set transmit-gain command to set the transmit-gain on a specific
port.
Displaying corrections
About this task
After correcting the balance, receive-gain or transmit-gain, you can view the corrections
applied to each port.
Monitoring applications
Administering Avaya G430 Branch Gateway October 2013 417