Avaya G430 - Page 470

Summary of OSPF commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level command Command Description
interface (dialer
fastethernet|
loopback|tunnel|
vlan)
Enter the Dialer, FastEthernet,
Loopback, Tunnel, or VLAN
interface context
bandwidth Set the bandwidth parameter
manually for this interface
ip ospf
authentication
Specify the authentication type for
an interface
no ip ospf
authentication
Remove the authentication type
for an interface.
ip ospf
authentication-
key
Configure the interface
authentication password
no ip ospf
authentication-
key
Remove the OSPF password
ip ospf cost Configure the Cost of an OSPF
interface, for the purpose of
determining the shortest path
no ip ospf cost Set the cost to its default value
ip ospf dead-
interval
Configure the interval before
declaring the neighbor as dead
no ip ospf dead-
interval
Set the dead-interval to its default
value
ip ospf hello-
interval
Specify the time interval between
hello packets sent by the router
no ip ospf hello-
interval
Set the hello-interval to its default
value
ip ospf message-
digest-key
Specify the message-digest key
for the interface and enable OSPF
MD5 authentication
The router
470 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com