Avaya G430 - Page 471

Root level command Command Description
no ip ospf
message-digest-
key
Return the interface to its default
value
ip ospf network
point-to-
multipoint
Specify the network type for the
interface
ip ospf network
point-to-
multipoint
Return the interface to its default
value
ip ospf priority Configure interface priority used in
Designated Router election
no ip ospf
priority
Set the OSPF priority to its default
value
ip ospf router-id Configure the router ID
no ip ospf router-
id
Return the router ID to its default
value
router ospf Enable OSPF protocol on the
system and to enter the router
configuration context
no router ospf Restore the default value and
disable OSPF globally
area Configure the OSPF area ID of the
router
no area Delete the OSPF area id
default-metric Set the interface OSPF route
metric value
network Enable OSPF in a network
no network Disable OSPF in a network. The
default value is disabled.
passive-interface Suppress OSPF routing updates
on an interface. Used to allow
interfaces to be flooded into the
OSPF domain as OSPF routes
rather than external routes.
Note:
Use the network command
with this command to make the
network passive.
The router
Administering Avaya G430 Branch Gateway October 2013 471