Avaya G430 - Page 608

Related topics:
Displaying synchronization status on page 608
Summary of synchronization commands on page 608
Displaying synchronization status
Procedure
Enter show sync timing to display the status of the local and remote primary,
secondary, and local clock sources.
The status can be Active, Standby, or Not Configured. The status is Not Configured
when a source has not been defined, for example, when there are no T1 cards
installed.
Example
Gxxx-???(super)# sh sync timing
SYNCHRONIZATION CONTROL: --- Local ---
SOURCE MM or VoIP STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary Not Configured
Secondary Not Configured
Local v0 Active None
Active Source: v0 Sync Source Switching: Enabled
Done!
Summary of synchronization commands
For more information about these commands, see Avaya Branch Gateway G430 CLI
Reference.
Command
Description
clear sync
interface
Disassociate a previously specified interface as the primary or
secondary clock synchronization source
set sync
interface
Define the specified module and port as a potential source for clock
synchronization for the Branch Gateway
set sync source Specify which clock source is the active clock source. The identity
of the current synchronization source is not stored in persistent
storage.
set sync
switching
Toggle automatic sync source switching
Synchronization
608 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com