Results from the set mgc list command
To determine the result of the set mgc list command, use the show mgc command. This
command has the following output:
Field Description
Registered Indicates whether or not the Branch Gateway
is registered with an MGC (YES or NO)
Active Controller Displays the IP address of the active MGC.
If there is no active MGC (that is, if the set
mgc list command failed to configure an
MGC), this field displays
255.255.255.255.
H248 Link Status Indicates whether the communication link
between the Branch Gateway and the MGC
is up or down
H248 Link Error Code If there is a communication failure between
the Branch Gateway and the MGC, this field
displays the error code
PRIMARY MGC HOST IPv4 and IPv6 addresses of the primary MGC
host
SECONDARY MGC HOST IPv4 and IPv6 addresses of the seconday
MGC hosts
Showing the current MGC list
About this task
This command shows the IP addresses of the MGCs on the MGC list. It also shows whether
or not SLS is enabled.
Procedure
To show the current MGC list, use the show mgc list command.
Example
Gxxx-001(super)# sh mgc list
PRIMARY MGC HOST, Primary Search Time : 1 min(s)
IPv4 Address IPv6 Address
-------------------- ----------------------------------------------
-- Not Available -- 100:0:0:0:0:0:0:803
SECONDARY MGC HOST
IPv4 Address IPv6 Address
-------------------- ----------------------------------------------
-- Not Available -- -- Not Available --
-- Not Available -- -- Not Available --
-- Not Available -- -- Not Available --
sls disabled
Basic device configuration
70 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
