Avaya G430 - Page 71

Done!
Removing MGCs from the MGC list
Procedure
Enter clear mgc list to remove one or more MGCs from the MGC list.
Specifically:
• To remove one or more MGCs from the MGC list, type the IP addresses of the
MGC you want to remove as an argument to remove that MGC.
• To remove more than one MGC with one command, type the IP addresses of all
the MGCs you want to remove, separated by commas.
• To remove all the MGCs on the list, enter clear mgc list with no
arguments.
Changing the MGC list
Procedure
1. Enter clear mgc list with no arguments to clear the MGC list.
2. Enter set mgc list with a different set of IP addresses.
Result
Note:
If you use the set mgc list command without first clearing the MGC list, the Branch
Gateway adds the new MGCs to the end of the MGC list.
About setting reset times
If the connection between the Branch Gateway and its registered MGC is lost, the Branch
Gateway attempts to recover the connection. Use the set reset-times primary-
search command and the set reset-times total-search command to set the timeout
for the Branch Gateway’s search for the primary MGC and the other MGCs on its MGC list,
respectively. Use the set reset-times transition-point command to configure the
point at which the primary MGCs in the list end and the LSPs begin.
Use the show recovery command to display the reset times.
Basic device configuration
Administering Avaya G430 Branch Gateway October 2013 71