9600 Series IP Deskphone Installation
24 9600 Series H.323 Deskphones Release 6.0 Installation and Maintenance Guide
Note:
Note:
The IPV6STAT parameter overrides both the DHCPSTAT parameter setting and
manual programming, therefore if DHCPSTAT is set to enable DHVPv6, it will be
disabled if IPV6STAT is "0" (disabled). Manual programming overrides
DHCPSTAT, therefore even if DHCPSTAT is set to enable DHCPv4 or DHCPv6,
the DoDHCPV4 or DoDHCPV6 will be set to "0" (disabled) if an IP Address of the
corresponding type has been manually programmed.
The DHCP server provides IP Addresses for the following hardware:
●
The IP telephone
●
The HTTP/HTTPS server
●
The TN799C or D Control-LAN (C-LAN) circuit pack on the media server
7. Using the list of gateway IP Addresses provided by the DHCP server, the telephone
performs a router check. The telephone cycles through the gateway IP Addresses with
ARPs or pings until it receives a response. When the router is located, received LLDP TLVs
are processed. Then the HTTP process starts.
8. While the IP telephone connects to the HTTP server, the telephone displays one of the
following messages:
where n is the number of the IP Address obtained from the HTTP server and ipadd is the IP
Address.
!
Important:
Important:
Pressing * at this time invokes the Craft Access entry procedure to allow manual
settings. For information, see Chapter 3:
Local Administrative (Craft) Options.
9. When connected, the telephone looks for an upgrade script file.
10. The HTTP server sends and identifies an upgrade script.
The GET message might have to be sent several times. Each time the GET message is
sent, all IP telephones display the following message:
For HTTP, n is the number of HTTP requests made by the telephone and uri is the URI for
the current HTTP request.
HTTP:n ipadd HTTP:n ipadd
* to program
HTTP: n uri
To Next Page
Loading...
Need help?
General
