Avery Dennison ADTP1 - Recommended Cutter Operation

Printing 6-5
Description of cut mode operation:
Cut Mode
Cut Before first tag
in Batch?
Cut Between
Tags?
Cut After
Batch?
Printed tags left between
printhead and cutter?
0
No No No No
1 Yes Yes Yes* Yes*
2 Yes No
(Feeds strips)
Yes* Yes
3
Yes Yes Yes
**
No*
4 No Yes Yes* Yes
5 Yes No (Feeds strips) Yes** No*
No* Cut Modes 3 and 5 minimize the number of tags left between the printhead and the cutter.
Depending on the length of supply being cut, there may be one tag left between the printhead and
the cutter.
Yes*
The last tag in the batch is queued to be cut once it reaches the cutter; however, there may be printed tags
left between the printhead and the cutter. The user must send another batch to feed the last tag out far
enough to be cut.
Note: Using “overstrike/continue” as the Error Action minimizes the number of RFID tags left
between the printhead and cutter. To use the least amount of RFID tags, set overstrike
to five.
Recommended Cutter Operation:
Printhead
Density
With
RFID
Supply
With
Stacker
Attached
Recommended Cut Modes
203
No No
1, 2, 4 –
Note
: Cut Modes 3 and 5 may cause ribbon tearing
203
No Yes
1, 2, 4 –
Note:
Cut Modes 3 and 5 may cause ribbon tearing
203
RFID is not supported with 203 dpi
203
RFID is not supported with 203 dpi
300*
No No 1, 2, 3, 4, 5
300*
No Yes 1, 2, 3, 4, 5
300*
Yes No 1, 2, 4
300*
Yes Yes
3, 5 – Note: Some RFID supplies may curl and cause a jam (with cut
mode 3). If this happens, use cut mode 1.
* Contact Service to order replacement 300 dpi printheads (KST) for use with the cutter and RFID
supplies.
E7. cut_mult Number of tags to print before cutting. A cut multiple of one cuts
after each tag. The range is 0 to 32,000. 0 is the default. The
cut multiple is a multiple of the print quantity. If the cut multiple
is three and the print quantity is 16, then five sets of three tags
and one set of one tag is produced.
Note: The last tag in the batch is always cut, regardless of the multiple.
E8. ver_mode Bar code verifier mode. Enables or disables the bar code verifier.
For more information about enabling the bar code verifier, refer
to the Verifier’s Operating Instructions. 0 is the default. Options:
0 Disable verifier - not using a verifier
1 Enable verifier