Avery Dennison ADTP1 - Defining the Memory Configuration Packet

2-18 Packet Reference Manual
See the following graphic for a representation of the following adjustments: dispense position,
backfeed distance, supply position, print position, and margin position.
Defining the Memory Configuration Packet
Use the memory configuration packet (M) to customize the size of the printer’s buffers.
Memory must be allocated in 1/2K increments. The memory configuration packet does not accept
decimals, so enter whole numbers. Multiply the amount to reallocate (in K) by 10. For example,
To reallocate (in K) Enter this amount
2.5 25
153 1530
229.5 2295
Each buffer’s allocated memory remains in effect until that buffer is reallocated. For this reason,
reallocate all the buffers when reallocating any buffer. Reallocating more memory than what is
available causes an error.
Syntax {I,M,buffer,device,buffer_size | }
M1. M Memory Configuration Packet
M2. buffer Buffer type. Options:
D Downloadable Fonts
F Format
I Image
M3. device Storage type. Use R for volatile RAM. Packets stored in volatile
RAM are deleted when the printer is turned off.
M4. buffer size Buffer size in 1/10K ranges. The following table lists the
configured buffer sizes and min-max values for the printer. The
printer’s configuration is stored in non-volatile RAM and saved
when the printer is turned off.
The maximum value for each buffer is listed; however, the sum of
all the buffers cannot exceed the maximum available memory of
the printer.