Avery Dennison ADTP1 - Defining the Supply Setup Packet

Configuring the Printer 2-7
Defining the Supply Setup Packet
Use the supply setup packet (B) to select supply type, ribbon, feed mode, supply position, and
cut position.
Syntax {I,B,supply_type,ribbon,feed_mode,supply_posn,cut_posn,
skip_index,cut_mode | }
B1. B Supply Setup Packet
B2. supply_type Supply Type. 1 is the default. Options:
0 Center Black mark
1 Edge Die Cut
2 Continuous (non-indexed)
3 Center Aperture
4 Reserved
5 Tag Edge Aperture (commonly with RFID)
6 Center Tag Edge
7 Edge Black Mark
8 Center Die Cut
Use continuous supply in continuous mode.
If the supply has black marks, always use black mark sensing
whether or not the supply has attacher holes.