3-26 Packet Reference Manual
Defining Line Fields
Use lines to form borders and mark out original prices. Define each line separately. This field is
not assigned a field number, but is counted as a field (keep this in mind, as the printer allows a
maximum of 1000 fields per format). Define any line length and a thickness up to 99 dots, as
long as the solid black print does not exceed 30 percent of any given square inch of the label.
Line Types
Create horizontal and vertical lines. There are two ways to define lines.
Segments Select the starting point and ending point.
Vectors Select the starting point, the angle, and the length of the line.
Syntax L,type,row,column,angle/end row,length/end col,
thickness,"pattern" |
L1. L Line Field.
L2. type Type of line. Only vertical and horizontal lines are supported.
S is the default. Options:
S Segment. Select the starting point and ending point.
V Vector. Select the starting point, angle, and length.
L3. row Row location - distance from bottom of
print area to the starting point. 10 is the
default.
English 0 – 1599
Metric 0 – 4063
203 Dots 0 – 3247
300 Dots 0 – 3599
L4. column Column location - distance from left edge of
the print area to line origin. 10 is the
default.
English 0 – 409
Metric 0 – 1039
203 Dots 0 – 831
300 Dots 0 – 1247
L5. angle If Using Segments:
/end row Row location of ending point. Measure from bottom
of print area. On horizontal lines, this value must
match item L3. 100 is the default.
English 0 – 1599
Metric 0 – 4063
203 Dots 0 – 3247
300 Dots 0 – 3599
If Using Vectors:
Angle of line. Options: 0, 90, 180, or 270.
0 is the default.
To Next Page
Loading...
