2-28 Packet Reference Manual
Defining a Verifier Configuration Packet
Use the verifier configuration packet to customize the verifier for each format. Select which bar
codes to scan, the acceptable ANSI grade levels, quiet zone, X-dimension range, etc.
Syntax V,format#,action,device,"name" |
D,"vfr_comds" |
V1. V Verifier Configuration Packet.
V2. format# Number from 0 to 999 to identify the format number that
corresponds to this particular verifier configuration packet.
Assign a verifier configuration packet to any format even if the
format number is not changed. See “Defining Verifier Fields” in
Chapter 3 for more information.
Note: Specify up to 50 different verifier configurations for the formats.
V3. action Action. Enter A to add a verifier configuration.
V4. device Storage device. Options:
F Flash. Stores the verifier configuration in the printer.
Packets stored in flash memory are saved when the power
is turned off.
T Temporary. Passes the packet through the printer and
stores the packet in the verifier. Packets stored in
temporary memory are lost when the power is turned off.
V5. “name” Packet name, 0 to 8 characters, enclose within quotation marks.
The name entered here is shown as a custom configuration on
the menu for MODE. Refer to the verifier’s Operating Instructions
(available on our Web site) for more information.
D1. D Non-Printable Text/Data Field.
D2. “vfr_comds” Verifier commands. Must be enclosed within quotation marks.
Refer to the SV Series Operators Guide for the complete list of
verifier commands.
Example V,1,A,T,"BEAMON" | D,"~LV02" |
The verifiers configuration packet ID is “1" and named “BEAMON." The verifier packet is added to
temporary memory. It uses Mode 2.
To Next Page
Loading...
