Avery Dennison ADTP1 - Page 30

2-14 Packet Reference Manual
The table represents the defined immediate command control character as ^ and the defined
status polling control character as d. These characters can be redefined if necessary.
Note: To use the immediate command control character or the status polling character within
data, use the tilde sequence.
Command
Parameter
^CA
Cancels all the batches in the printer's queue unless an error exists on the
printer.
Note: This does not cancel batches in the printer's receive buffer.
^CB
Cancels only the current batch being printed unless an error exists.
^CT
Cut command.
^DD or
^DCd
Disables the MPCL data escape character (the tilde) and inhibits MPCL from
acting on ANY data escape sequence from the host. Sets the MPCL data
escape character to the ASCII value given by the d parameter. The value can
be any ASCII character.
^DLD
Disables data logging
^DLE
Enables data logging
^EA
Aborts an error condition. This command is the same as pressing ESCAPE to
clear an error. May need to be sent multiple times. Use ^RB to reprint batch.
CAUTION: This command causes the current batch to stop and the condition
that caused the error to remain uncorrected.
^ER
Resets the error. This command is the same as pressing FEED to
acknowledge an error. Normal operation resumes.
^FD
Feeds a label when printer is idle. Simulates the operation of pressing FEED
and dispenses the next label if printer is in the on-demand mode.
Note:
Printer ignores this command if printing.
^FF1
Formats flash memory
^FF2
Returns the amount (in bytes) of the available flash memory.
^GD
Disables the conversion of formats designed in 203 dpi dot units to 300 dpi.
^GE
Enables the conversion of formats designed in 203 dpi dot units (not English
or Metric) to 300 dpi.
^ID or
^ICd
Disables the Immediate Command feature by turning off the Immediate
Command escape character. Sets the Immediate Command escape character
to the ASCII value given by the d parameter. The value can be any ASCII
character. Use ^IE to enable immediate commands.
^LE
Uploads the last successful EPC encoded data in ASCII Hex format to the last-
used communication port/channel. (^).
^MC
Returns the customer ID or RPQ version to the host. (00 to 99)
^MD
Returns the printhead dot density to the host. 00 = 203 dpi 01 = 300 dpi
^MI
Returns the customer ID or RPQ revision level to the host. (00 to 99)
^MM
Returns the model number to the host. M46 = ADTP1
^MP
Returns the prototype number to the host. (00 to 99)
^MR
Returns the revision number to the host. (00 to 99)
^MV
Returns the version number to the host. (00 to 99)
^NR
Performs a network factory reset.