Defining Fields 3-3
T7. gap Number of dots between characters in 203 dpi (or 300 dpi).
Range: 0 to 99.
0 is the default.
Note: For monospaced fonts, the additional spacing is added to the
existing inter-character gap. This is also true for proportionally
spaced fonts; however, the inter-character gap varies with
character combinations.
Any number other than 0 affects the field width. Default spacing:
Standard 3 dots
Reduced 1 dot
Bold 3 dots
OCRA-like 3 dots
CG Triumvirate™ Typeface Bold varies with each letter
CG Triumvirate™ Typeface varies with each letter
T8. font Style of font. 1 is the default. Options:
1 Standard 10 CG Triumvirate™ Typeface Bold
2 Reduced 11 CG Triumvirate™ Typeface
3 Bold 15 7 pt. CG Triumvirate™ Typeface
4 OCRA-like 16 9 pt. CG Triumvirate™ Typeface
5 HR1 17 11 pt. CG Triumvirate™ Typeface
6 HR2 18 15 pt. CG Triumvirate™ Typeface
50 EFF Swiss Bold (TrueType® Scalable)
56 PaxarSymbols
Or a valid downloaded font selector number.
Fonts 5 and 6 are for numeric data only. The CG Triumvirate™
typefaces support only the ANSI and DOS Code Page 437 and
850 Symbol Sets. The scalable font does not support Code Page
1256 (Arabic). See Appendix C
for more information.
T9. hgt mag Height magnifier, 1 to 7 times (4 to 255 points for
scalable/downloaded TrueType fonts). 1 is the default. Use a
magnifier of 1 with proportionally spaced fonts, because
characters lose smoothness at higher magnifications. See
Appendix B, “Fonts
,” for more information about fonts.
T10. wid mag Width magnifier, 1 to 7 times (4 to 255 points for
scalable/downloaded TrueType fonts). 1 is the
default.Proportionally spaced fonts do not have a set width. To
estimate the size of the field, use the letter “W” for the widest
field or an “L” for an average width field. Find the selected font
and the desired width in Appendix B, “Fonts
.”
To Next Page
Loading...
