Avid S6 Installation Guide22
3 Secure the Side Wall to the Back and Front Tie Plates using Hex fasteners and tighten them fully.
4 If your system does not include Legs, proceed to Step 6.
5 If your system includes a Leg Frame, place the first chassis on the right End Bracket and Beams and secure it loosely from un-
derneath using Hex fasteners (included with the Beams) as shown in Figure 18. Make sure the pins on the top of the Beams align
with and fit through the openings in the Chassis Bottom Plate. Do not fully tighten the fasteners yet.
Figure 16. Attaching the end Side Wall to the Producers Desk Inlay Chassis (for systems with a Producers Desk being installed at the far
right end, only)
Figure 17. Attaching the end Side Wall to the Back and Front Tie Plates
Figure 18. Attaching the first chassis to the End Bracket and Beams of a Leg Frame
(Not to scale)
M5x8 FHCS (7760-30553-00)
Fastener
M3 Hex
Tool
(Not to scale)
M6x14 SOC (7760-30605-00)
Fastener
M6 (7760-30606-00)
Washer
Tool
M5 Hex
To Next Page
Loading...
Need help?
General
