Avid S6 Installation Guide56
Installing Master Section Modules
Installing the Automation Module is nearly identical to installing a Fader Module.
Installing the Automation Module
To install the Automation Modules:
1 If you haven’t already done so, unpack the Automation Module and Master Module.
2 Hold the Automation module above its chassis and do the following:
• Connect the longest 2-pin Molex power cable to the DC input on the side of the module.
• Connect the longest Ethernet cable to the Ethernet port on the side of the module.
3 Install the connected Automation Module into the first (front-most) slot of the chassis. Make sure the module sits completely
into the frame and not on any cables
Automation Module in slot 1 of the chassis (switch and PSUs not shown)
Slot 1
Automation
Module
To Next Page
Loading...
Need help?
General
