Chapter 6: Installing Modules 55
8 If your system includes two Knob Modules in a Frame Chassis Large, do the following:
• Connect power to the second Knob Module.
• Take one of the included 12-inch Ethernet cables you installed earlier (see “Short Ethernet Cables for Knob Modules and Dis-
play Modules” on page 46), and connect the other end to the Knob Module.
• Install the second Knob Module in slot 4, directly above the first Knob Module. Make sure the module sits completely into
the frame and not on any cables or other modules.
9 Repeat the previous steps for all other Channel modules.
Example of a Frame Chassis Large with one Fader Module, one Process Module and two Knob Modules
Channel Modules installed (switch and PSUs not shown)
Slot 1
Slot 3
Slot 2
Slot 4
Fader
Process
Knob
Knob
Module
Module 2
Module 1
Module
Slot 3
Knob
Slot 2
Process
Slot 1
Fader
Module
Module
Module
To Next Page
Loading...
Need help?
General
