IFD500 Series Pilot Guide
Aux Subsystem 5-25
If editing was initiated by touch or if the field was touched at any
time while editing is active, a virtual keyboard will appear. The
keyboard is used to enter the desired value. It is possible to enter
values using the keyboard that are out of bounds for the setting.
Therefore, once accepted, the edited value may be adjusted to be
a valid value for the setting.
The CLR key is used during editing as a backspace key.
However, if the value being edited is empty, one more press of
the CLR key will cancel the edit. At any time during the edit,
pressing the Cancel LSK or pressing the virtual keyboard red-X
will also cancel the edit.
Pressing the right knob button, the ENTR button, the ENTR key
the virtual keyboard, or the Enter LSK will accept the edited value
as the new setting.
To Next Page
Loading...
