Designated waypoint identifier, bearing
from present position to the designated
waypoint, radial from the designated
waypoint to present position, straight
line distance from present position to
the designated waypoint, and
estimated time enroute from present
position to the designated waypoint.
Note: to change the designated
waypoint, touch the datablock to
display the virtual keyboard. Type in
the designated waypoint identifier and
press Enter. The designated
waypoint will persist across power
cycles.
Destination identifier, total distance to
destination along the remaining flight
plan legs, estimated fuel at destination
(if fuel flow installed) and estimated
time enroute to the destination.
Format of ETE in all datablocks is
HH:MM until the ETE is less than 10
minutes. Then it goes to MM:SS.
To Next Page
Loading...
