IFD500 Series Pilot Guide
1-40 System Overview
When the desired waypoint is displayed, press the knob
button or ENTR key to accept
Touch the waypoint field in the dialog box to generate a
virtual keyboard and then use the keyboard to enter the
desired waypoint identifier. It may not be necessary to
enter every character, since the field is managed by
Geofill. When the desired waypoint is displayed, press
the knob button, the ENTR key, or “Enter” on the keypad
to accept
Turn the bottom right inner knob to start editing the
identifier. Use the inner knob to change characters and
the outer knob to change cursor position. It may not be
necessary to enter every character, since the field is
managed by Geofill. When the desired waypoint is
displayed, press the knob button or the ENTR key to
accept.
To Next Page
Loading...
